Skip to content

Filtration Academy

Filtration Academy. Filtration principles, selection and validation.

Articles on how filtration works, from micron ratings to validation, written by Gopani application engineers, and the sizing tools in development. The articles can be read in order or individually.

Start here

Five short articles that cover the basics used throughout the Filtration Academy.

  1. Basics

    What a micron rating promises

    The number on the label, the test behind it and the efficiency it implies.

    Read
  2. Basics

    Nominal and absolute

    Why the same rating can retain very different amounts.

    Read
  3. Basics

    Depth and surface filtration

    Where particles are held, and what that does to life and cost.

    Read
  4. Basics

    Reading a differential pressure curve

    What the slope says about the fluid, the pre-filter and the change-out day.

    Read
  5. Selection

    How to size a pre-filter

    Size on the solids it will hold, so the stage after it does not blind.

    Read

Tools

The calculations used to size a filtration stage. Each tool is in development.

In development

Filtration cost calculator

Annual filtration cost for cartridge options, including change-outs, downtime and disposal.

Notify me
In development

Chemical compatibility checker

A fluid checked against membrane, media, seal and housing materials at the operating temperature.

Notify me
In development

Unit converter

Flow, pressure, viscosity and retention between the units your datasheets use.

Notify me
In development

Flow and pressure drop estimator

Clean differential pressure for a cartridge count, flow rate and fluid viscosity.

Notify me

Suggest a tool

Requests for other calculations are considered when planning the next tools.

Suggest a tool

Curriculum

A reading path from the basics to selection to validation. Each step assumes the one before it.

Start at step one

BasicsHow filtration works

  1. What a micron rating promises. The number, the test behind it and the efficiency it implies.

  2. Nominal and absolute. Why the same rating can retain very different amounts.

  3. Depth and surface filtration. Where particles are held, and what that does to life and cost.

  4. Reading a differential pressure curve. What the slope says before the cartridge reaches its limit.

SelectionChoosing the stage

  1. How to size a pre-filter. Dirt load first, micron rating second.

  2. Choosing a membrane. PES, PVDF, PTFE or nylon, by fluid, temperature and sterility.

  3. Sizing a train stage by stage. From bag to final cartridge, so no stage carries the load of another.

  4. Choosing a housing. Flow, pressure, material and the seal that holds the rating.

ValidationProving it works

  1. Integrity testing. Bubble point, diffusion and what a failed test is telling you.

  2. Compatibility before the first batch. Testing the fluid against media, seals and housing.

  3. Change-out records. What to keep from every change-out and test, so an audit reads the line.

Ask an application engineer

For a question not covered here, send the line, the fluid and the duty. An application engineer will reply.

Ask an application engineer
  • Download the catalogues

    Catalogues for every family, as PDF.

    Download catalogues
  • Read the field problems

    Common filtration problems, causes and corrective actions.

    Field problems

Download a catalogue

Tell us who you are once and every catalogue opens.

By sending this you agree to our Privacy notice.